Hollow shaft, 1.312 in. Bore dia; 2nd end keyway is 180 degrees from cross drilled hole
A shaft having two or more different diameters (greater than 0.031 inches (0.79 millimeter)) along its length. It must have one or more of the following conditions: a specified surface finish designation in the range 1 to 125 microinches (0.025 to 3.2 micrometers) arithmetical average (aa), machined peripheral flat(s), circular groove(s), keyway(s), splines, threads, or holes. The ends and/or shoulders may be machined to accommodate bearings, couplings, and the like. It is not designed for use in aligning by fitting into corresponding holes of another item. For items used to support rotating members see axle(1), shouldered. For items not having any of the above conditions see pin, shoulder, headless. Excludes shaft(1), straight; and axle(1), straight.
Classification: Transmission shafts and cranks, except camshafts and crankshafts
NSN 5925-01-573-8257
NSN 6645-00-888-5820
NSN 2925-00-411-0600
NSN 6145-01-145-5177
NSN 6645-00-017-8252
NSN 5895-01-100-3759
NSN 5985-01-476-8978
NSN 4140-00-456-2268
NSN 6650-00-629-8027
NSN 6240-01-354-9457
NSN 6645-00-654-8804
NSN 5835-01-072-6760