Hollow shaft, 1.312 in. Bore dia; 2nd end keyway is 180 degrees from cross drilled hole
A shaft having two or more different diameters (greater than 0.031 inches (0.79 millimeter)) along its length. It must have one or more of the following conditions: a specified surface finish designation in the range 1 to 125 microinches (0.025 to 3.2 micrometers) arithmetical average (aa), machined peripheral flat(s), circular groove(s), keyway(s), splines, threads, or holes. The ends and/or shoulders may be machined to accommodate bearings, couplings, and the like. It is not designed for use in aligning by fitting into corresponding holes of another item. For items used to support rotating members see axle(1), shouldered. For items not having any of the above conditions see pin, shoulder, headless. Excludes shaft(1), straight; and axle(1), straight.
Classification: Transmission shafts and cranks, except camshafts and crankshafts
NSN 5990-01-024-9659
NSN 7035-01-440-1862
NSN 5905-00-824-9681
NSN 5910-01-082-2570
NSN 5935-00-154-3063
NSN 5905-00-508-0819
NSN 6145-01-527-9377
NSN 4140-00-034-7935
NSN 5915-01-641-1266
NSN 5960-01-459-4944
NSN 6320-01-195-5583
NSN 6105-00-915-8331